Forgive me if that has already been presented. I have searched the Forum for this issue with no luck finding anything. Here is my issue:
I recently purchased a Dell m1000e chassis, but I have an issue with an M600 blade specifically. Once I get this issue resolved, I can fully populate the chassis. For now, this is holding me up.
I installed Windows 2003 R2 from an OEM image I built. The driver installation for the Broadcom NIC recognizes the NIC, and installed it, but I get "This device cannot start (Code 10)" for both NICs.
I have 2x M6220 switches in the chassis as A1 and A2
Could this issue be related to the switch configuration, or is this a blade hardware or driver issue?
Thanks for looking. Any help is greatly appreciated.