Hi all,
I have an issue with a M620 blade I was tasked to rebuild XenServer 6.0 on - initially I couldn't connect to the iDRAC and after updating this I could then get virtual console access to the server ok and be able to attach the iso required etc.. but upon restart there is no 'virtual CD' to choose for the boot as shown in the numerous guides I've had a look at for this. I've also tried launching the media from the UEFI boot options (as well as updating the BIOS to only use that methos) but no joy for any of this.
The ISO is definitely ok as I attached this to a VM and it boots straight into the XenServer setup. I've not got much experience at all with the DELL hardware as I was pulled in to look at this so any advise is greatly appreciated it as I have been at this on and off for days.
Thanks,
Will